Connect CGDI MB Prog to W212 OBD port,run software and select “EIS”–>”Read EIS Data”
Select “Compute Password”–>”Copy key without key”,and it mean all key lost programming
Follow the instruction to insert the simulation key into the EIS in 30 seconds…
Now it starting collecting data,it will take a long time,please don’t disconnect the device
After the collecting progress completing,save the file with the default name.
It prompt “Save the file successfully.Please upload the data to calculate password”
Now,click “Upload Data” to upload the data file you save just now
Upload data successfully,please click the [Query Result] button to query
Click “Query Result”
Calculate password successfully
Click “Copy” button to copy the password
Select “EIS” menu,then click ”Paste” to paste key password
Save EIS data with default file name
Select “Generate EE”–>click “Load EIS File” to check EIS data information
It prompt you “The key file was generated successfully”
Now select “Read/Write Key”
Insert the new key into the CGDI MB
Tick “Infrared”,then click “Read Key/Chip”
Click “Reset” button to erase key
Click “Open/Write” button
Please Note:Smart key please choose 41 format,common key and BE key please choose 51 format!When writing the original key,please make sure that it is wiped by the CGMB,otherwise the write will fail!
Click “OK” to continue
Now select a unused key file
Now you can click “Read EIS Data” again to check the position key 2 is used,and if your key work correctly,it mean your programming is successful.