2020 New Release V6.26 X-PROG XPROG-M ECU Chip Programmer Add More New Authorizations
Please Attention For Xprog V6.26 Software Installation Tips:
1. MUST Connect Internet
2. PC Time MUST adjust to Accurate Local Time
3. MUST first install 6.26registry,then run V6.26 Software
Please must follow this instructions to run software,otherwise device will not installed.
Please MUST READ THIS :
1. Which XPROG version you use, before open software MUST install the right version registry. Otherwise it will runs old version registry automically and then confilt with new hardware and device dead.
2. If your computer no install other old xprog version,it also require install right registry ,otherwise device runs fault and defective .
XPROG-M V6.26 Software Add New Authorizations and Chip Supported List Part Display:
Package List:
1pc x XPROG-Box Hardware (Aluminum Enclosure)
19pc x Adapters Set
1pc x USB Cable
1pc x 16Pin cable
1pc x CD with XPROG-Box Software (V6.26)
We Also Recommend
LP99P15A-1
Best Quality SOP8 to DIP8 Clamp 8-PIN 1.27mm SOP-8 IC Test Clip with Cable
LP99P001
[TL866-3G] Original XGecu T48 Programmer for EPROM/MCU/SPI/Nor/NAND Flash/EMMC/ IC TESTER/ TL866CS TL866II Replacement