PCMflash Software- 92 Module Bosch MD1/MG1 Bootloader (support Scanmatik, Mongoose Pro MFC, Tactrix Openport)
PCMflash Software- 92 Module Bosch MD1/MG1 Bootloader (support Scanmatik, Mongoose Pro MFC, Tactrix Openport)
Notice:
Software module to work with Bosch MD1 and MG1 ECUs in direct connection to the ECU connector. This module is designed for reading, writing, and servicing engine control units using SPC572L, SPC574K, SPC5777M, SPC58, TC275TP, TC277TP, TC298TP, TC299TP, TC387QP and TC399XP microcontrollers.
To use the module, you need to purchase a USB dongle. The key can be purchased in our store. You can purchase an unlimited number of modules with one key
Support Models:
- MD1/MG1 FLASH (SPC572L/SPC574K/SPC5777M/SPC58/TC275TP/TC277TP/TC298TP/TC299TP/TC387QP/TC399XP) [RD/WR/CK]
- MD1/MG1 EEPROM (SPC572L/SPC574K/SPC5777M/SPC58/TC275TP/TC277TP/TC298TP/TC299TP/TC387QP/TC399XP) [RD/WR]
- MG1UA008/MG1US008 FLASH (SPC574K/TC277TP) [RD/WR/CK]
- MG1UA008/MG1US008 EEPROM (SPC574K/TC277TP) [RD/WR]
RD – Read, VR – Virtual Read (converter or stocks), WR – Write, CK – Check/Correction of Checksum, NC – No Checksum Used
The module enables direct bootloader access to Bosch MD1/MG1 ECUs, which is critical for chip tuning and software recovery. It supports ECUs with older security systems (manufactured before mid-2020). ECUs with the newer protection system are not supported.
Compatible Interface:
Tested with the following adapters Scanmatik 2/Pro/3, Mongoose Pro MFC, Tactrix Openport 2.0. A boot bench cable or Powerbox for PCMflash is required for automatic power and boot pin control.
