Original Combiloader V3 ECU Programmer with OBD2 Cable, DB25 Adapter ECUTOOLs Chip-Tuning Tool

Loader v.3 - a program for reading and writing firmware in engine control units of domestic and imported cars. Allows firmware without removing the ECU from the car, using the OBD2 connector, for those types of ECUs where it is possible. The loader is convenient to use, reliable, has many additional functions, is updated and supported by technical support.

Manufacturer: Russian company "AVTOELECTRIC".

Please note: The software interface has been translated into English though some modules are still in Russian only. Help section is available only in the Russian language.

Please note: The purchase of Combiloader must be accompanied by the purchase of one of the module license services

The kit includes a USB protection key, and subsequently purchased modules are tied to the key.

In case of key loss, modules CANNOT be restored.

Attention! The Combiloader is not sold without a module! You must add at least one module to your order. Orders without module will be cancelled. The money transfer fee may be lost.

Program capabilities:

• ability to create dual-mode firmware for Janvar-5.1, Janvar-7.2, VS-5.1, and Mikas-7.1
• removal of additional error masks in the latest versions of factory software
• protection against reading by self-destruction of firmware when attempting to read
• embedding starter lock functions in the program code
• embedding a route computer with 20 functions in the program code
• protection against copying by setting the number of illegal starts
• simultaneous work with a pair of FLASH / EEPROM
• correction of all firmware identifiers
• reading the immobiliser status and disabling it
• correction of passport data stored in EEPROM
• removal of additional checksum verification
• correction of checksums
• Error correction in serial software

Basic Set Modules:

• BSL mode C16x: a wide range of imported and domestic vehicles equipped with ECU based on C16x microcontrollers.
• BSL mode ST10F168: any types of ECUs with ST10F168 family processors, such as MagnetiMarelli IAW 59F installed in Fiat cars.
• BSL mode ST10F27x: a wide range of imported and domestic vehicles equipped with ECU based on ST10F27x microcontrollers.
• BSL mode ST10F280: any types of ECUs with ST10F280 family processors, such as MagnetiMarelli 6LPB installed in Peugeot cars.
• BSL mode ST10F296: any types of ECUs with ST10F296 family processors, such as MagnetiMarelli 4HV installed in Skoda Octavia/Fabia with 1.4L engine (BUD).
• January-5.1: VAZ vehicles.
• January-7.2: VAZ vehicles.
• VS-5.1: VAZ vehicles.
• Bosch C509 Hyundai/Kia: Hyundai/Kia vehicles with ECU based on C509 processors with external Am29F010 FLASH.
• Bosch MP7.0: VAZ vehicles.
• Bosch M7.9.7(+): VAZ vehicles, Bosch M7.9.7 ECU.
• Mikas-7.1: GAZ and UAZ vehicles.
• Mikas-7.6: ZAZ and Daewoo vehicles.

All other modules are purchased separately. To purchase modules, you need to provide the host number and key serial number. You can find both numbers in the program itself through the menu ("Help" - "About the program").

Some modules require a J2534 adapter, such as Dialink, OpenPort 2.0, Scanmatic 2 PRO.

Package List:

• Software Package LOADER V3 (COMBILOADER)
• USB Host
• Adapter
• USB Key
• DB25 Adapter
• OBD2 Cable