PCMflash Software- 89 Module China MG1 (support Scanmatik, Mongoose Pro MFC, Tactrix Openport)
PCMflash Software- 89 Module China MG1 (support Scanmatik, Mongoose Pro MFC, Tactrix Openport)
Notice:
Software module to work with MG1 family ECUs installed in Chinese cars.
To use the module, you need to purchase a USB dongle. The key can be purchased in our store. You can purchase an unlimited number of modules with one key
Support Models:
- BAIC 1.5L A151A1 (MG1UA008) [RD/WR/CK] [RD/WR/CK]
- Changan 1.4T, 1.5T, 2.0T (UD8/MG1US008) [RD/WR/CK]
- Chery/Exeed 2.0T F4J20 (MG1US008) [RD/WR/CK]
- DongFeng 1.5T (UP8/MG1US008) [RD/WR/CK]
- FAW 1.5T, 2.0T (UD8/MG1US008) [RD/WR/CK]
- Ranger 2.3L Ecoboost China (MG1US008) [P3N9] [RD/WR/CK]
- Geely 1.5L (MG1UA008) [RD/WR/CK]
- Geely/Livan 1.5T (MG1US708) [Test] [RD/WR/CK]
- Great Wall/Haval 1.5T, 2.0T (MG1US008) [RD/WR/CK]
- Haval Jolion 1.5T (MG1UA008) [RD/WR/CK]
- JAC T9 2.0T (UD8/MG1US008) [RD/WR/CK]
- JAC J7 1.5T (UP8/MG1UA008) [RD/WR/CK]
- SGMW 1.5L/1.5T N15A/N15T (MG1UA008) [RD/WR/CK]
- SWM 1.5T (MG1UA008) [RD/WR/CK]
VR - virtual reading, RD - reading, WR - writing , CK - verification and checksum correction, NC - checksum not used.
Reading and writing through the car's diagnostic connector is supported, as well as checksum verification and correction. Direct connection to the ECU connector may be required for reading (currently in pre-facelift Haval F7/F7x).
Compatible Interface:
Tested with the following adapters Scanmatik 2/Pro/3, Mongoose Pro MFC, Tactrix Openport 2.0. A boot bench cable or Powerbox for PCMflash is required for automatic power and boot pin control.
